hi
i've had a 20" impact reagent pro (32mm) frame and a isis impact 36 hole hub since a while.
i am using 22-32-7RS (x4) or 22-32-14RS (x2) bearings depending on what is available.
they wear out very quickly. my current bearings just broke after 5 sessions (in addition it was only flat sessions, no big street jump)
i tried tight/loosened, with/without loctite, with/without spacer for isis hub... i even tried with/without washers between the frame and the bearing clamps. i don't know what to do...
even if they're new before they were installed on my unicycle, these bearings didn't turn very well in my fingers.
in addition, this dimension of ball bearings is very rare and i have trouble finding any.
do you have the same problems? do you have any solutions? any alternatives?
i'm thinking about changing the frame for this reason...
maybe for a 20" impact reagent pro (42mm) or 20" nimbus equinox pro (42mm)... but maybe i should change the seatpost and the hub?